How To Install And Remove Hydraulic Breaker Tool

2.Tool Removal

1)    To remove the tool, drive out the retainer pin and 

stopper plug using the drift supplied in the tool kit.

2)    Use the drift to drive out the tool retainers. 

Inspect them for cracks or deformities and wear on the edge

that rests against the tool.

NOTE: Models SK20, SK30, SK40, SK43 have spring tool 

retainer pins / other larger models have round tool 

retainer pins.

Ensure tool retainer pins (SK45 and  larger  model)  are rotated 

properly. 

Check for hash mark where pin contacts front head pin.

3)    Remove any burrs on the retainer pins and the tool with a grinder. 

Check for mushrooming on the top of tool.

4)    If rotating the retainer pins, make sure the marked surface is 

towards the tool as shown.